H3C S5120-EI Series - Page 4

Command reference Added and modified commands
Loopback and null interface
configuration commands
Added commands: reset counters interface null
Modified commands: reset counters interface is changed into
reset counters interface loopback
MAC address table
configuration commands
None
MAC Information
configuration commands
None
Ethernet link aggregation
configuration commands
Added commands:
• display interface bridge-aggregation
• lacp period short
• link-aggregation lacp traffic-redirect-notification enable
• link-aggregation load-sharing mode local-first
Port isolation configuration
commands
None
MSTP configuration
commands
Added commands: display stp bpdu-statistics
BPDU tunneling configuration
commands
• None
VLAN configuration
commands
Added commands:
• mac-vlan trigger enable
• port pvid disable
Isolate-user-VLAN
configuration commands
Added commands:
• isolated-vlan enable
• port isolate-user-vlan
Voice VLAN configuration
commands
Added commands:
• voice vlan qos
• voice vlan qos trust
GVRP configuration
commands
None
QinQ configuration
commands
Added commands: qinq transparent-vlan
LLDP configuration
commands
None
Conventions
This section describes the conventions used in this documentation set.
Command conventions
Convention Description
Boldface Bold text represents commands and keywords that you enter literally as shown.
Italic Italic text represents arguments that you replace with actual values.
[ ]
Square brackets enclose syntax choices (keywords or arguments) that are
optional.