H3C S5120-EI Series - Page 82

70
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 829 packets, 58795 bytes
7 unicasts, 790 broadcasts, 32 multicasts, 0 pauses
Output (normal): 829 packets, - bytes
7 unicasts, 790 broadcasts, 32 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
# Display brief information about Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> display interface bridge-aggregation 1 brief
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Interface Link Speed Duplex Type PVID Description
BAGG1 DOWN auto A A 1
# Display information about all Layer 2 aggregate interfaces in DOWN state.
<Sysname> display interface bridge-aggregation brief down
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
BAGG1 ADM Administratively
Table 15 Output description
Field Description
Bridge-Aggregation1/Route-Aggr
egation1 current state
The Layer 2 aggregate interface status, which can be:
• DOWN ( Administratively )—The interface is administratively shut
down with the shutdown command.
• DOWN—The interface is administratively up but physically down
(possibly because no physical link is present or the link is faulty).
• UP—The Ethernet interface is both administratively and physically up.
1Gbps-speed mode, full-duplex
mode
The interface speed is 1Gbps and duplex mode is full duplex mode.
PVID The default VLAN ID.
Last clearing of counters
Time when the reset counters interface command was last used to clear
the interface statistics.
Never indicates the reset counters interface command has never been
used on the current interface since the device’s startup.
Last 300 seconds input/output The average input/output rate over the last 300 seconds.
Input/Output (total) The statistics of all packets received/sent on the interface.
Input/Output (normal) The statistics of all normal packets received/sent on the interface.
The brief information of interface(s)
under bridge mode
Brief information about Layer 2 interfaces.
Link: ADM - administratively down;
Link status: