EasyManuals Logo

H3C S5500-EI User Manual

H3C S5500-EI
490 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #185 background imageLoading...
Page #185 background image
166
Ste
p
Command
Remarks
7. Enable PIM-SM.
pim sm Disabled by default.
For more information about the ip vpn-instance, route-distinguisher, and ip binding vpn-instance
commands, see IP Routing Command Referenc
e.
Enabling BIDIR-PIM
Perform this configuration on all routers in the BIDIR-PIM domain.
To enable BIDIR-PIM:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter public network PIM view
or VPN instance PIM view.
pim [ vpn-instance
vpn-instance-name ]
N/A
3. Enable BIDIR-PIM.
bidir-pim enable Disabled by default
Configuring an RP
An RP can be manually configured or dynamically elected through the BSR mechanism. For a large PIM
network, static RP configuration is a tedious job. Generally, static RP configuration is just used as a
backup means for the dynamic RP election mechanism to enhance the robustness and operation
manageability of a multicast network.
When both PIM-SM and BIDIR-PIM run on the PIM network, do not use the same RP to provide services
for PIM-SM and BIDIR-PIM. Otherwise, exceptions might occur to the PIM routing table.
Configuring a static RP
If only one dynamic RP exists in a network, manually configuring a static RP can avoid communication
interruption because of single-point failures and avoid frequent message exchange between C-RPs and
the BSR.
In BIDIR-PIM, a static RP can be specified with a virtual IP address. For example, if the IP addresses of the
interfaces at the two ends of a link are 10.1.1.1/24 and 10.1.1.2/24, you can specify a virtual IP address,
like 10.1.1.100/24, for the static RP. As a result, the link becomes an RPL.
To make a static RP to work normally, you must perform this configuration on all routers in the BIDIR-PIM
domain and specify the same RP address.
To configure a static RP:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5500-EI and is the answer not in the manual?

H3C S5500-EI Specifications

General IconGeneral
BrandH3C
ModelS5500-EI
CategorySwitch
LanguageEnglish

Related product manuals