H3C S5500-EI - Configuring BIDIR-PIM; BIDIR-PIM Configuration Task List; Configuration Prerequisites

164
Ste
p
Command Remarks
2. Enter public network PIM view
or VPN instance PIM view.
pim [ vpn-instance
vpn-instance-name ]
N/A
3. Disable the switchover to SPT.
spt-switch-threshold infinity
[ group-policy acl-number
[ order order-value] ]
Optional.
By default, the device switches to the
SPT immediately after it receives the
first multicast packet.
Configuring BIDIR-PIM
BIDIR-PIM configuration task list
Task Remarks
Enabling PIM-SM Required.
Enabling BIDIR-PIM Required.
Configuring an RP
Configuring a static RP
Required.
Use any approach.
Configuring a C-RP
Enabling auto-RP
Configuring C-RP timers globally Optional.
Configuring a BSR
Configuring a C-BSR Required.
Configuring a BIDIR-PIM domain border Optional.
Configuring global C-BSR parameters Optional.
Configuring C-BSR timers Optional.
Disabling BSM semantic fragmentation Optional.
Configuring an admin-scope zone
boundary
Enabling administrative scoping Optional.
Configuring administrative scoping Optional.
Configuring C-BSRs for each admin-scope
zone and the global-scope zone
Optional.
Configuring PIM common features Optional.
Configuration prerequisites
Before you configure BIDIR-PIM, complete the following tasks:
• Configure a unicast routing protocol so that all devices in the domain can reach each other.
• Determine the IP address of a static RP and the ACL that defines the range of the multicast groups
to which the static RP is designated.
• Determine the C-RP priority and the ACL that defines the range of multicast groups to which each
C-RP is designated.