H3C S5500-EI - Setting the DSCP Value for Ipv6 PIM Messages; Displaying and Maintaining Ipv6 PIM

417
Setting the DSCP value for IPv6 PIM messages
IPv6 uses an eight-bit Traffic class field (called ToS in IPv4) to identify type of service for IP packets. As
defined in RFC 2474, the first six bits contains the DSCP priority for prioritizing traffic in the network and
the last two bits are reserved.
To set the DSCP value for IPv6 PIM messages:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Set the DSCP value for IPv6
PIM messages.
dscp dscp-value
Optional.
By default, the DSCP value in IPv6
PIM messages is 48.
Displaying and maintaining IPv6 PIM
Task Command Remarks
Display the BSR information in the
IPv6 PIM-SM domain and locally
configured C-RP information in
effect.
display pim ipv6 bsr-info [ |
{ begin | exclude | include }
regular-expression ]
Available in any view
Display information about IPv6
unicast routes used by IPv6 PIM.
display pim ipv6 claimed-route
[ ipv6-source-address ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Display the number of IPv6 PIM
control messages.
display pim ipv6 control-message
counters [ message-type { probe |
register | register-stop } |
[ interface interface-type
interface-number | message-type
{ assert | bsr | crp | graft |
graft-ack | hello | join-prune |
state-refresh } ] * ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Display the DF information of IPv6
BIDIR-PIM.
display pim ipv6 df-info
[ rp-address ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display information about
unacknowledged graft messages.
display pim ipv6 grafts [ | { begin
| exclude | include }
regular-expression ]
Available in any view
Display the IPv6 PIM information
on an interface or all interfaces.
display pim ipv6 interface
[ interface-type interface-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view