H3C S5500-EI - Ipv6 PIM Configuration Examples; Ipv6 PIM-DM Configuration Example

418
Task Command Remarks
Display information about
join/prune messages to send.
display pim ipv6 join-prune mode
{ sm [ flags flag-value ] | ssm }
[ interface interface-type
interface-number | neighbor
ipv6-neighbor-address ] *
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display IPv6 PIM neighboring
information.
display pim ipv6 neighbor
[ interface interface-type
interface-number |
ipv6-neighbor-address | verbose ]
* [ | { begin | exclude | include }
regular-expression ]
Available in any view
Display information about the IPv6
PIM routing table.
display pim ipv6 routing-table
[ ipv6-group-address
[ prefix-length ] |
ipv6-source-address
[ prefix-length ] |
incoming-interface [ interface-type
interface-number | register ] |
outgoing-interface { include |
exclude | match } { interface-type
interface-number | register } |
mode mode-type | flags flag-value
| fsm ] * [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display the RP information.
display pim ipv6 rp-info
[ ipv6-group-address ] [ | { begin |
exclude | include }
regular-expression ]
Available in any view
Reset IPv6 PIM control message
counters.
reset pim ipv6 control-message
counters [ interface interface-type
interface-number ]
Available in user view
IPv6 PIM configuration examples
IPv6 PIM-DM configuration example
Network requirements
Receivers receive VOD information through multicast. The receiver groups of different organizations form
stub networks, and one or more receiver hosts exist in each stub network. The entire IPv6 PIM domain is
operating in the dense mode.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
MLDv1 runs between Switch A and N1 and between Switch B/Switch C and N2.