H3C S5500-EI - Configuring an Ipv6 Multicast Group Filter; Setting the Maximum Number of Ipv6 Multicast Groups that an Interface Can Join

347
Configuration procedure
To configure a static member of an IPv6 multicast group or an IPv6 multicast source and group:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure a static member of
an IPv6 multicast group or an
IPv6 multicast source and
group.
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
By default, an interface is not a
static member of any IPv6 multicast
group or IPv6 multicast source and
group.
Configuring an IPv6 multicast group filter
To restrict the hosts on the network attached to an interface from joining certain IPv6 multicast groups,
you can set an IPv6 ACL rule on the interface so that the interface maintains only the IPv6 multicast
groups matching the criteria.
To configure an IPv6 multicast group filter:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an IPv6 multicast
group filter.
mld group-policy acl6-number
[ version-number ]
By default, no IPv6 group filter is
configured on the interface. That is,
hosts on the current interface can
join any valid multicast group.
Setting the maximum number of IPv6 multicast groups that an
interface can join
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure the maximum number of
IPv6 multicast groups that the
interface can join.
mld group-limit limit 1000 by default.