H3C S5500-EI - Enabling Ipv6 PIM-SM; Enabling Ipv6 BIDIR-PIM

400
• Determine the C-RP priority and the IPv6 ACL that defines the range of IPv6 multicast groups to
which each C-RP is designated.
• Determine the legal C-RP address range and the IPv6 ACL that defines the range of IPv6 multicast
groups to which the C-RP is designated.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the IPv6 ACL defining the legal BSR address range.
• Determine the BS period.
• Determine the BS timeout.
Enabling IPv6 PIM-SM
You must enable IPv6 PIM-SM before enabling IPv6 BIDIR-PIM because IPv6 BIDIR-PIM is implemented on
the basis of IPv6 PIM-SM. To deploy an IPv6 BIDIR-PIM domain, enable IPv6 PIM-SM on all non-border
interfaces of the domain.
IMPORTANT:
On a router, all interfaces in the same VPN instance must operate in the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IPv6 multicast routing.
multicast ipv6 routing-enable Disabled by default
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable IPv6 PIM-SM.
pim ipv6 sm Disabled by default
Enabling IPv6 BIDIR-PIM
Perform this configuration on all routers in the IPv6 BIDIR-PIM domain.
To enable IPv6 BIDIR-PIM:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Enable IPv6 BIDIR-PIM.
bidir-pim enable Disabled by default