H3C S5500-EI - Configuring Ipv6 MBGP Route Redistribution; Configuring Ipv6 MBGP Route Summarization; Advertising a Default Route to a Peer or Peer Group

453
Ste
p
Command Remarks
4. Inject a network into the IPv6
MBGP routing table.
network ipv6-address prefix-length
[ route-policy route-policy-name | short-cut ]
Not injected by default.
Configuring IPv6 MBGP route redistribution
Ste
p
Command Descri
p
tion
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP multicast
address family view.
ipv6-family multicast N/A
4. Enable default route
redistribution into the IPv6
MBGP routing table.
default-route imported
Optional.
By default, default route
redistribution is not allowed.
If the default-route imported
command is not configured, using
the import-route command cannot
redistribute any IGP default route.
5. Enable route redistribution
from another routing protocol.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Not enabled by default.
Configuring IPv6 MBGP route summarization
To reduce the routing table size on medium and large BGP networks, you must configure route
summarization on IPv6 MBGP routers. BGP supports only manual summarization of IPv6 multicast routes.
To configure IPv6 MBGP route summarization:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP
address family view.
ipv6-family multicast N/A
4. Configure manual
route summarization.
aggregate ipv6-address prefix-length [ as-set |
attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name
| suppress-policy route-policy-name ]*
Not configured by
default.
Advertising a default route to a peer or peer group