H3C S5500-EI - Configuring Multicast VLAN Ports

69
Ste
p
Command Remarks
2. Enter interface view or port
group view.
• Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either command.
3. Configure the user port link
type as hybrid.
port link-type hybrid Access by default
4. Specify the user VLAN that
comprises the current user
ports as the default VLAN.
port hybrid pvid vlan vlan-id VLAN 1 by default
5. Configure the current user
ports to permit packets of the
specified multicast VLANs to
pass and untag the packets.
port hybrid vlan vlan-id-list
untagged
By default, a hybrid port permits
only packets of VLAN 1 to pass.
For more information about the port link-type, port hybrid pvid vlan, and port hybrid vlan commands,
see Layer 2—LAN Switching Command Reference.
Configuring multicast VLAN ports
In this approach, you configure a VLAN as a multicast VLAN and assign user ports to it. You can do this
by either adding the user ports in the multicast VLAN or specifying the multicast VLAN on the user ports.
These two methods provide the same result.
Configuration guidelines
• For the S5500-EI switches, you cannot configure multicast VLAN on a device with multicast routing
enabled.
• The VLAN to be configured as a multicast VLAN must exist.
• A port can belong to only one multicast VLAN.
Configuration procedure
To configure multicast VLAN ports in multicast VLAN view:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the specified VLAN
as a multicast VLAN and enter
multicast VLAN view.
multicast-vlan vlan-id
By default, a VLAN is not a
multicast VLAN.
3. Assign ports to the multicast
VLAN.
port interface-list
By default, a multicast VLAN has
no ports.