H3C S5500-EI - Displaying and Maintaining Ipv6 Multicast VLAN; Ipv6 Multicast VLAN Configuration Examples; Sub-VLAN-Based Multicast VLAN Configuration Example

320
Ste
p
Command Remarks
3. Configure the ports as
member ports of the IPv6
multicast VLAN.
port interface-list
By default, an IPv6 multicast
VLAN has no member ports.
To configure IPv6 multicast VLAN ports in interface view or port group view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the specified
VLAN as an IPv6 multicast
VLAN and enter IPv6
multicast VLAN view.
multicast-vlan ipv6 vlan-id
Not an IPv6 multicast VLAN
by default.
3. Return to system view.
quit N/A
4. Enter interface view or
port group view.
• Enter Layer 2 Ethernet interface view or
Layer 2 aggregate interface view:
interface interface-type interface-number
• Enter port group view:
port-group manual port-group-name
Use either command.
5. Configure the ports as
member ports of the IPv6
multicast VLAN.
port multicast-vlan ipv6 vlan-id
By default, a user port does
not belong to any IPv6
multicast VLAN.
Displaying and maintaining IPv6 multicast VLAN
Task Command Remarks
Display information about an IPv6
multicast VLAN.
display multicast-vlan ipv6
[ vlan-id ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
IPv6 multicast VLAN configuration examples
Sub-VLAN-based multicast VLAN configuration example
Network requirements
As shown in Figure 80, MLDv1 runs on Router A, and MLDv1 snooping runs on Switch A. Router A acts
as the MLD querier. The IPv6 multicast source sends IPv6 multicast data to the IPv6 multicast group
FF1E::101. Host A, Host B, Host C, and Host D are receivers of the IPv6 multicast group. The hosts belong
to VLAN 2 through VLAN 5 respectively.
Configure the sub-VLAN-based IPv6 multicast VLAN feature on Switch A so that Router A just sends IPv6
multicast data to Switch A through the IPv6 multicast VLAN and Switch A forwards the traffic to the
receivers that belong to different user VLANs.