H3C S5500-EI - Page 340

321
Figure 80 Network diagram
Configuration procedure
1. Enable IPv6 forwarding on each device and configure an IPv6 address and address prefix for
each interface as per Figure 80. (Details
not shown.)
2. On Router A, enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface and enable
MLD on the host-side interface GigabitEthernet 1/0/2.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim ipv6 dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim ipv6 dm
[RouterA-GigabitEthernet1/0/2] mld enable
3. Configure Switch A:
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 2 through VLAN 5.
[SwitchA] vlan 2 to 5
# Configure GigabitEthernet 1/0/2 as a trunk port that permits packets from VLAN 2 and VLAN
3 to pass through.
Source
G
E
1
/
0
/
2
GE
1
/
0
/
3
Switch A
MLD querier
Router A
GE1/0/1
1::2/64
GE1/0/2
2001::1/64
1::1/64
GE1/0/1
Switch B Switch C
G
E
1
/
0
/
1
G
E
1
/
0
/
1
Receiver
Host A
VLAN 2
Receiver
Host B
VLAN 3
Receiver
Host C
VLAN 4
Receiver
Host D
VLAN 5
GE1/0/2 GE1/0/3 GE1/0/2 GE1/0/3