H3C S5500-EI - Configuring Ipv6 MBGP Route Attributes; Configuration Prerequisites; Configuring Ipv6 MBGP Route Preferences; Configuring the Default Local Preference

456
Ste
p
Command Remarks
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Configure IPv6 MBGP route
dampening parameters.
dampening [ half-life-reachable
half-life-unreachable reuse
suppress ceiling | route-policy
route-policy-name ]*
Optional.
Not configured by default.
Configuring IPv6 MBGP route attributes
This section describes how to use IPv6 MBGP route attributes to affect IPv6 MBGP route selection. IPv6
MBGP route attributes involve:
• IPv6 MBGP protocol preference
• Default LOCAL_PREF attribute
• MED attribute
• NEXT_HOP attribute
• AS_PATH attribute
Configuration prerequisites
Before you configure IPv6 MBGP route attributes, complete the following tasks:
• Enable IPv6.
• Configure basic IPv6 MBGP functions.
Configuring IPv6 MBGP route preferences
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Configure preferences for
external, internal, and local
IPv6 MBGP routes.
preference { external-preference
internal-preference
local-preference | route-policy
route-policy-name }
Optional.
The default preference values of
external, internal, and local routes
are 255, 255, and 130,
respectively.
Configuring the default local preference