399
Ste
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Disable the switchover to
SPT.
spt-switch-threshold infinity
[ group-policy acl6-number
[ order order-value ] ]
Optional.
By default, the device switches to the SPT
immediately after it receives the first IPv6
multicast packet from the RPT.
Configuring IPv6 BIDIR-PIM
IPv6 BIDIR-PIM configuration task list
Task Remarks
Enabling IPv6 PIM-SM Required.
Enabling IPv6 BIDIR-PIM Required.
Configuring an RP
Configuring a static RP
Required.
Use any a
pproach.
Configuring a C-RP
Enabling embedded RP
Configuring C-RP timers globally Optional.
Configuring a BSR
Configuring a C-BSR Required.
Configuring an IPv6 BIDIR-PIM domain border Optional.
Configuring global C-BSR parameters Optional.
Configuring C-BSR timers Optional.
Disabling BSM semantic fragmentation Optional.
Configuring IPv6 administrative
scoping
Enabling IPv6 administrative scoping Optional.
Configuring an IPv6 admin-scope zone boundary Optional.
Configuring C-BSRs for each admin-scope zone Optional.
Configuring IPv6 PIM common features Optional.
Configuration prerequisites
Before you configure IPv6 BIDIR-PIM, complete the following tasks:
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain can communicate with each other at Layer 3.
• Determine the IPv6 address of a static RP and the IPv6 ACL that defines the range of IPv6 multicast
groups to which the static RP is designated.
To Next Page
Loading...
Need help?
General