185
Task Command Remarks
Display the content of the PIM
routing table.
display pim [ all-instance |
vpn-instance vpn-instance-name ]
routing-table [ group-address
[ mask { mask-length | mask } ] |
source-address [ mask
{ mask-length | mask } ] |
incoming-interface [ interface-type
interface-number | register ] |
outgoing-interface { include |
exclude | match } { interface-type
interface-number | register } |
mode mode-type | flags flag-value
| fsm ] * [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display the RP information.
display pim [ all-instance |
vpn-instance vpn-instance-name ]
rp-info [ group-address ] [ | { begin
| exclude | include }
regular-expression ]
Available in any view
Reset PIM control message
counters.
reset pim [ all-instance |
vpn-instance vpn-instance-name ]
control-message counters
[ interface interface-type
interface-number ]
Available in user view
PIM configuration examples
PIM-DM configuration example
Network requirements
As shown in Figure 53, receivers receive VOD information through multicast. The receiver groups of
different organizations form stub networks, and one or more receiver hosts exist in each stub network. The
entire PIM domain is operating in the dense mode.
Host A and Host C are multicast receivers in two stub networks.
IGMPv2 runs between Switch A and N1 and between Switch B/Switch C and N2.
To Next Page
Loading...
