H3C S5500-EI - Configuring Basic Ipv6 MBGP Functions; Configuration Prerequisites; Configuring an Ipv6 MBGP Peer

451
Task Remarks
Configuring IPv6
MBGP route
attributes
Configuring IPv6 MBGP route preferences
Optional
Configuring the default local preference
Configuring the MED attribute
Configuring the NEXT_HOP attribute Optional
Configuring the AS_PATH attribute Optional
Tuning and
optimizing IPv6
MBGP networks
Configuring IPv6 MBGP soft reset Optional
Enabling the IPv6 MBGP orf capability Optional
Configuring the maximum number of equal-cost routes for
load-balancing
Optional
Configuring a large
scale IPv6 MBGP
network
Configuring an IPv6 MBGP peer group Optional
Configuring IPv6 MBGP community Optional
Configuring an IPv6 MBGP route reflector Optional
Configuring basic IPv6 MBGP functions
Configuration prerequisites
IPv6 MBGP is an application of multiprotocol BGP. Before you configure IPv6 MBGP, complete the
following tasks:
• Enable IPv6.
• Configure network layer addresses for interfaces.
• Complete BGP basic configuration.
Configuring an IPv6 MBGP peer
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enable BGP and enter BGP view.
bgp as-number Not enabled by default.
3. Enter IPv6 address family view. ipv6-family N/A
4. Specify an IPv6 BGP peer and its AS
number.
peer ipv6-address as-number
as-number
Not configured by default.
5. Enter IPv6 MBGP address family
view.
ipv6-family multicast N/A
6. Enable the IPv6 MBGP peer. peer ipv6-address enable Not enabled by default.