465
Task Command Remarks
Display the multicast routing
information of the specified
destination address.
display ipv6 multicast routing-table ipv6-address
prefix-length [ longer-match ] [ verbose ] [ | { begin |
exclude | include } regular-expression ]
Available in
any view
Resetting IPv6 MBGP connections
When you change an IPv6 MBGP routing policy, you can make the new configuration effective by
resetting the IPv6 MBGP connections.
Task Command Remarks
Reset the specified IPv6
MBGP connections.
reset bgp ipv6 multicast { as-number |
ipv6-address [ flap-info ] | all | group
ipv6-group-name | external | internal }
Available in user view
Clearing IPv6 MBGP information
Task Command Remarks
Clear dampened IPv6 MBGP
routing information and release
suppressed routes.
reset bgp ipv6 multicast dampening
[ ipv6-address prefix-length ]
Available in user view
Clear IPv6 MBGP route flap
statistics.
reset bgp ipv6 multicast flap-info
[ ipv6-address/prefix-length | regexp
as-path-regexp | as-path-acl
as-path-acl-number ]
Available in user view
IPv6 MBGP configuration example
Network requirements
As shown in the following figure:
• IPv6 PIM-SM 1 is in AS 100, and IPv6 PIM-SM 2 is in AS 200. OSPFv3 is the IGP in the two ASs,
and IPv6 MBGP runs between the two ASs to exchange IPv6 multicast route information.
• The IPv6 multicast source belongs to IPv6 PIM-SM 1 and the receiver belongs to IPv6 PIM-SM 2.
• The VLAN-interface 101 of Switch A and Switch B must be configured as the C-BSR and C-RP of the
IPv6 PIM-SM domains.
• Enable the imbedded RP function for all switches in IPv6 PIM domain.
To Next Page
Loading...
