H3C S5500-EI - Ipv6 PIM-SSM Configuration Example

444
00001. RP Address: 6001::1
MID: 0, Flags: 0x2100000:0
Uptime: 00:05:12
RPF interface: Vlan-interface103
List of 2 DF interfaces:
1: Vlan-interface300
2: Vlan-interface400
IPv6 PIM-SSM configuration example
Network requirements
Receivers receive VOD information through multicast. The receiver groups of different organizations form
stub networks, and one or more receiver hosts exist in each stub network. The entire PIM domain is
operating in the SSM mode.
Host A and Host C are IPv6 multicast receivers in two stub networks, N1 and N2.
The SSM group range is FF3E::/64.
MLDv2 runs between Switch A and N1 and between Switch B/Switch C and N2.
Figure 109 Network diagram
Device Interface IPv6 address Device Interface IPv6 address
Switch A Vlan-int100 1001::1/64 Switch D Vlan-int300 4001::1/64
Vlan-int101 1002::1/64 Vlan-int101 1002::2/64
Ethernet
EthernetEthernet
N1N2
Vlan-
int101
Vlan-
i
nt
101