H3C S5500-EI - Protocols and Standards; Configuring Ipv6 PIM-DM; Ipv6 PIM-DM Configuration Task List

385
Figure 104 Relationship among IPv6 PIM protocols
For more information about MLD SSM mapping, see "Configuring MLD (available only on the
S5500-EI)."
Protocols and standards
• RFC 3973, Protocol Independent Multicast-Dense Mode(PIM-DM):Protocol Specification(Revised)
• RFC 4601, Protocol Independent Multicast-Sparse Mode (PIM-SM): Protocol Specification (Revised)
• RFC 3956, Embedding the Rendezvous Point (RP) Address in an IPv6 Multicast Address
• RFC 5015, Bidirectional Protocol Independent Multicast (BIDIR-PIM)
• RFC 5059, Bootstrap Router (BSR) Mechanism for Protocol Independent Multicast (PIM)
• RFC 4607, Source-Specific Multicast for IP
• draft-ietf-ssm-overview-05, An Overview of Source-Specific Multicast (SSM)
Configuring IPv6 PIM-DM
IPv6 PIM-DM configuration task list
Task Remarks
Enabling IPv6 PIM-DM Required
Enabling state-refresh capability Optional