H3C S5500-EI - Displaying and Maintaining Ipv6 PIM Snooping; Ipv6 PIM Snooping Configuration Example

310
Ste
p
Command Remarks
7. Enable IPv6 PIM snooping in
the VLAN.
pim-snooping ipv6 enable
Disabled by default
Displaying and maintaining IPv6 PIM snooping
Task Command Remarks
Display IPv6 PIM snooping
neighbor information.
display pim-snooping ipv6
neighbor [ vlan vlan-id ] [ slot
slot-number ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display IPv6 PIM snooping routing
entries.
display pim-snooping ipv6
routing-table [ vlan vlan-id ] [ slot
slot-number ] [ | { begin | exclude
| include } regular-expression ]
Available in any view
Display the statistics information of
IPv6 PIM messages learned by IPv6
PIM snooping.
display pim-snooping ipv6
statistics [ | { begin | exclude |
include } regular-expression ]
Available in any view
Clear the statistics information of
IPv6 PIM messages learned by IPv6
PIM snooping.
reset pim-snooping ipv6 statistics Available in user view
IPv6 PIM snooping configuration example
Network requirements
As shown in Figure 76, Source 1 sends multicast data to IPv6 multicast group FF1E::101, and Source 2
sends multicast data to IPv6 multicast group FF2E::101. Receiver 1 belongs to multicast group FF1E::101,
and Receiver 2 belongs to multicast group FF2E::101. Router C and Router D run MLD on their interface
GigabitEthernet 1/0/1. Router A, Router B, Router C, and Router D run IPv6 PIM-SM, and interface
GigabitEthernet 1/0/2 on Router A acts as a C-BSR and C-RP.
Configure MLD snooping and IPv6 PIM snooping on Switch A so that Switch A forwards IPv6 PIM
messages and multicast data to only the routers that are interested in the multicast data.