H3C S5500-EI - Page 330

311
Figure 76 Network diagram
Configuration procedure
1. Enable IPv6 forwarding on the devices, configure an IPv6 address and prefix length for each
interface according to Figure 76. (Details not shown.)
2. On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and configure
interface GigabitEthernet 1/0/2 as a C-BSR and C-RP.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim ipv6 sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim ipv6 sm
[RouterA-GigabitEthernet1/0/2] quit
[RouterA] pim ipv6
[RouterA-pim6] c-bsr 1001::1
[RouterA-pim6] c-rp 1001::1
3. On Router B, enable IPv6 multicast routing, and enable IPv6 PIM-SM on each interface.
<RouterB> system-view
[RouterB] multicast ipv6 routing-enable
[RouterB] interface gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] pim ipv6 sm
[RouterB-GigabitEthernet1/0/1] quit
[RouterB] interface gigabitethernet 1/0/2
[RouterB-GigabitEthernet1/0/2] pim ipv6 sm
4. On Router C, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable
MLD on GigabitEthernet 1/0/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface gigabitethernet 1/0/1