H3C S5500-EI - Configuring Ipv6 Multicast VLAN Ports

319
To configure user port attributes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or port
group view.
• Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either command.
3. Configure the user port link
type as hybrid.
port link-type hybrid Access by default.
4. Specify the user VLAN that
comprises the current user
ports as the default VLAN.
port hybrid pvid vlan vlan-id VLAN 1 by default.
5. Configure the current user
ports to permit packets of the
specified IPv6 multicast VLAN
to pass and untag the packets.
port hybrid vlan vlan-id-list
{ tagged | untagged }
By default, a hybrid port permits
only packets of VLAN 1 to pass.
For more information about the port link-type, port hybrid pvid vlan, and port hybrid vlan commands,
see Layer 2—LAN Switching Command Reference.
Configuring IPv6 multicast VLAN ports
In this approach, you configure a VLAN as an IPv6 multicast VLAN and assign user ports to it. You can
do this by either adding the user ports in the IPv6 multicast VLAN or specifying the IPv6 multicast VLAN
on the user ports. These two methods provide the same result.
Configuration guidelines
• For the S5500-EI switches, you cannot configure an IPv6 multicast VLAN on a device with multicast
routing enabled.
• The VLAN to be configured as an IPv6 multicast VLAN must exist.
• A port can belong to only one IPv6 multicast VLAN.
Configuration procedure
To configure IPv6 multicast VLAN ports in IPv6 multicast VLAN view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the specified VLAN
as an IPv6 multicast VLAN
and enter IPv6 multicast
VLAN view.
multicast-vlan ipv6 vlan-id
No IPv6 multicast VLAN
configured by default.