48
!
"
ISK 3
ø 250
ø 300
ø 315
min 2 mm
max 4 mm
!
"
§
$
%
&
Saw-Spindle Moulder
B3 / B3 e-classic
Making adjustments and preparations
8.10.3 Removing the splitter
Fig. 8-22: Removing the splitter
1. Loosen the nut.
2. Remove the splitter.
3. Tighten the nut.
!Nut
"Splitter
Attention!
A splitter is required when working with circular saw blades!
Operation without the splitter is only allowed if dado tooling is used!
The saw guard is mounted onto the splitter. The mounting
depends on the diameter of the saw blade:
• Recess for saw blades from 300 to 315 mm
• Recess for saw blades from 250 mm
1. Loosen the thumb nut.
2. Push the hood stud to the back with the thumb nut.
3. Remove the saw guard and insert into the other re-
cess.
4. Secure the thumb nut.
!Splitter
"Hood stud
§Thumb nut
$Circular saw guard
%Recess for saw blades from 300 to 315 mm
&Recess for saw blades from 250 mm
8.10.4 Circular saw guard
Fig. 8-23: Circular saw guard
Warning! Risk of injury!
When working with the circular saw blade, the machine‘s saw blade should be equipped with a saw guard
to avoid injuries!
To Next Page
Loading...
