82
Saw-Spindle Moulder
B3 / B3 e-classic
11.3.9 Moulding with a power feeder
Fig. 11-11: Moulding with a power feeder
1. Take note of general procedures for authorized
working techniques.
2. If required, set up the power feeder.
3. Adjust the power feeder.
4. If you are not going to continue working, switch off
the machine and secure it against being turned on
again accidentally.
11.3.10 Moulding with a high velocity spindle
Fig. 11-12: High velocity spindle
In addition, the machine can be equipped with a high
velocity spindle.
1. Take note of general procedures for authorized
working techniques.
2. Mount the spindle moulder fence or the EURO Curve
moulding guard as a protective device.
3. Press the workpiece against the fence and spindle
table and feed past the spindle moulder tool with
fingers and thumbs balled into a fist.
4. If you are not going to continue working, switch off
the machine and secure it against being turned on
again accidentally.
Note: The high velocity spindle is especially designed for dovetail or duplicate mouldings. Only use original
manufacturer tools.
Operation
To Next Page
Loading...