86
!
!
"
#
$
%
Saw-Spindle Moulder
B3 / B3 e-classic
12.6 Checking the scoring belt
Fig. 12-5: Scoring belt
The scoring belt is tensioned elastically and thus mainte-
nance free.
Should cracks or lateral tears appear during the monthly
control check, replace the scoring belt with a new one
(assembly instructions „Scoring unit“).
! Scoring belt
12.7 Cleaning/changing the dust brush of the outrigger arm
Fig. 12-6: Dust brush (outrigger arm)
1. Clean the dust brush and check if in good condition.
2. Renew the dust brush if it is worn out, that is if the
outer slider is no longer cleaned:
• Loosen the socket head cap screw and washer
from the outrigger arm.
• Remove the worn out dust brush.
• Insert a new dust brush.
• Screw the dust brush onto the outrigger arm with
a socket head cap screw and washer.
! Outrigger arm
" Socket head cap screw
# Washer
$ Dust brush
% Outer slider
Maintenance
To Next Page
Loading...
