83
Saw-Spindle Moulder
B3 / B3 e-classic
Maintenance
12 Maintenance
12.1 Safety instructions
Warning! Risk of injury: Improper maintenance can cause serious injury or damage. For this reason this work
may only be carried out by authorised, trained personnel who are familiar with the operation of the machine
and in strict observance of all safety instructions.
• Before beginning any maintenance work on the machi-
ne, switch it off and secure it against accidentally being
switched on again.
• Ensure that there is sufficient space to work around the
machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Following the maintenance work, re-install the guards
and check that they are functioning properly.
12.2 Maintenance schedule
Attention: Cleaning and care products are available as accessories (HAMMER-catalogue).
Warning! Danger – electric current: Work on electrical fittings may only be carried out by qualified personnel
and in strict observance of the safety instructions.
Interval Component Task to accomplish
Daily Machine Remove dust and shavings.
Table surfaces Remove dust and shavings. Remove
any resin residue
Guide tracks Remove dust and shavings. Remove
any resin residue
Dust extractor Check for defects
Weekly Machine Clean thoroughly.
Every 40 operating hours, At least
once a month
Height and tilting spindle Control and lubrication (if required).
Monthly Drive belt Check and if required, tighten or
change
Scoring belt Check:
Dust extractor Check efficiency
Every quarter
(or sooner should the machine be-
come stiff)
Spindle moulder socket and Tilting
segments
Lubrication.
every 6 months Dust brush (outrigger arm) Clean and if necessary, renew.
If worn out Wiper (rolling cage) Renew.
To Next Page
Loading...
Need help?
General
