76
Saw-Spindle Moulder
B3 / B3 e-classic
11.1 Safety instructions
Warning! Risk of injury! Improper operation may lead to severe physical injury or material damage. For this
reason, this work may only be carried out by authorised, trained personnel who are familiar with how to
operate the machine and in strict observance of all safety instructions.
11 Operation - Spindle moulder unit
Before starting work:
• Before commencing any work with the machine,
inspect it to ensure that it is complete and in
technically good condition.
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Ensure that all safety devices have been installed
properly.
• Adjustments to the machine or tool replacement may
only be conducted once the machine has stopped.
• Only clamp authorised tools to the machine.
• Pull the clamping srew of the moulder spindle tight.
• Adapt the speed to the tooling
• Only work with sharp tools. This reduces the kick-
back risk especially with slotted blades
• Install the dust extraction system according to the
instructions and test its function.
• Only machine workpieces that can be safely placed
on the machine and guided.
• Carefully inspect workpieces for foreign matter (nails,
screws) which might impair processing.
• Ensure that the tool turns freely.
• Pay attention to the correct rotational direction of the
spindle moulder tool
• Before switching on the machine, always check to make
sure that there are no other persons in the immediate
vicinity of the machine.
During operation:
• When changing to another workpiece or if a
malfunction occurs, first switch off the machine and
then secure it against being switched on again
accidentally.
• Do not switch off, circumvent or decommission
protective and safety devices during operation.
• Risk of injury from ejected tool pieces (e.g. cutting
pieces).
When working on or with the machine, the following
must be strictly observed:
• Persons with long hair who are not wearing a hairnet
are not permitted to work on or with the machine!
• It is prohibited to wear gloves while working on or
with the machine.
When working on or with the machine, the following
must always be worn by personnel:
• Sturdy, tight-fitting clothing (tear-resistant, no wide
sleeves, no jewellery (rings, bracelets, necklaces,
etc.)).
• Protective footwear - To protect the feet from heavy
falling objects and prevent sliding on slippery floors
• Hearing protection - To protect against loss of hea-
ring
Note: Accessories:
Support long workpieces with additional surface equipment.
(e.g. Table extensions, roll supports)
Keep tools for handling short and narrow workpieces close at hand.
(e.g.: Push grip, Clamping jigs)
We recommend using a removable feed mechanism for shaping larger workpieces on the fence or for work in
series.
Operation
To Next Page
Loading...
Need help?
General
