Harmonic MediaGrid - Page 209

Chapter 7 Administrative Procedures
© 2017 Harmonic Inc. All rights reserved. 209 Harmonic MediaGrid Release 4.1
Using mgcopy to Copy Files Between Harmonic MediaGrid Systems
When opened, mgcopy presents a command line interface. Use the mgcopy command with
additional values shown in Table 7–1 to perform a copy.
Note the following usage:
mgcopy [-s content director][-u user][-p password][-s2 content
director2][-u2 user2][-p2 password2][-d debuglevel][-copy
<deep|soft|across>][-srcfile src-file-name][-dstfile dst-file-name][-
o][-c][-copyOwner][-copyAcl][-logfile file-name][-errorfile file-
name][-testRun][-noDataTransfer][-help]
NOTE: If you are using mgcopy to copy files that include hardlinks, and the files already exist in the
destination path, make sure to use the overwrite option shown in Table 7–1.