Chapter 7 Administrative Procedures
© 2017 Harmonic Inc. All rights reserved. 215 Harmonic MediaGrid Release 4.1
Powering Down a Harmonic MediaGrid System
13. From the SystemManager platform, click the Start button on the taskbar, and then click Shut
Down
to shut down the SystemManager platform. Disconnect the power cord if necessary.
14. Power down the Network Switches by disconnecting the power cords.
Powering Down or Restarting a Single ContentDirector
1. From the Configuration tab, click the Servers & Switches icon in the left-hand column to
open the
Servers & Switches page.
2. In the
ContentDirectors section, click the name of the ContentDirector you wish to power
down. The
ContentDirector Properties page appears.
3. Click the
Shutdown button located at the bottom of the General Properties section.
4. When the confirmation message appears, click
OK.
5. Check the
Status field to verify that it indicates Not Responding. Note that this may take a few
minutes depending on the length of the discovery cycle and the status of other devices in
your network.
6. Disconnect the power supply.
To restart a single ContentDirector without removing the power supply:
1. From the ContentDirector Properties page, click the
Reboot button located at the bottom of
the General Properties section.
2. When the confirmation message appears, click
OK. The ContentDirector will restart.
3. Check the
Status field to verify that it changes to Not Responding, and then returns to its
previous state. Note that it may take a few minutes for the status to change, depending on the
length of the discovery cycle and the status of other devices in your network.
Powering Down or Restarting a Single ContentBridge
To power down a single ContentBridge:
1. From the
Configuration tab, click the Servers & Switches icon in the left-hand column to
open the
Servers & Switches page.
2. In the
ContentBridge section, click the name of the ContentBridge you wish to power down.
The
ContentBridge Properties page appears.
3. Click the
Shutdown button located at the bottom of the General Properties section.
4. When the confirmation message appears, click
OK.
5. Check the
Status field to verify that it indicates Not Responding. Note that it may take a few
minutes for the status to change, depending on the length of the discovery cycle and the
status of other devices in your network.
6. Disconnect the power supply.
To restart a single ContentBridge without removing the power supply:
1. From the ContentBridge Properties page, click the
Reboot button located at the bottom of the
General Properties section.
2. When the confirmation message appears, click
OK. The ContentBridge will restart.
3. Check the
Status field to verify that it changes to Not Responding, and then returns to its
previous state. Note that it may take a few minutes for the status to change, depending on the
length of the discovery cycle and the status of other devices in your network.
To Next Page
Loading...
