EasyManua.ls Logo

Harmonic MediaGrid - Earlier

Harmonic MediaGrid
358 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 4 System Configuration
© 2017 Harmonic Inc. All rights reserved. 141 Harmonic MediaGrid Release 4.1
Joining a Harmonic MediaGrid Cluster to an Apple Open Directory Domain
NATIVE <Cluster_IP_address_or_DNS_name> <file system name>
Restarting gateway and heartbeat Services
Enter the following command to restart gateway services:
service gateway start
IMPORTANT: After restarting gateway services, test the output of /etc/samba/smb.conf by running
testparm and verify that server signing is not set to “required” or “auto,” or is not present.
Enter the following command to restart heartbeat services (for High Availability pairs only):
service heartbeat start
Verifying Communication Using smbclient
Enter one of the following commands to verify communication with the Open Directory server:
From the client computer, type
smbclient -U <username> -W <domain_name>
\\\\<IP_address_of_HBCB>\\<fs_share>
From the High Bandwidth ContentBridge, type
smbclient -U <username> -W <domain_name> \\\\localhost\\<fs_share>
If successful, smbclient will respond with the following prompt:
smb: \>
NOTE: Make sure the Harmonic MediaGrid cluster is also configured with Apple Open Directory.
NOTE: Make sure that winbind service is stopped. If you do not stop the winbind service on the High
Bandwidth ContentBridge, it will interfere with authentication when you attempt to access the Harmonic
MediaGrid using CIFS.
NOTE: In order to access the Harmonic MediaGrid, the individual users must be added to the Apple Open
Directory domain.
NOTE: If you have previously modified the following configuration files for use with a different directory
service, and you are unable to join the High Bandwidth ContentBridge to the Open Directory server (OS X
10.11 or later), please contact Technical Support for assistance:
/etc/nsswitch.conf, /etc/krb5.conf, /
etc/ldap.conf.
Joining a High Bandwidth ContentBridge to an Open Directory Server with
OS X 10.6.8 or Earlier
Follow the procedures in this section in order.
NOTE: In order to join a High Bandwidth ContentBridge to an Open Directory with OS X 10.6.8 or earlier,
an LDAP or Open Directory server must already be configured to serve as Samba Primary Domain Controller
for the LDAP or Open Directory domain.

Table of Contents

Related product manuals