Harmonic MediaGrid - Page 214

Chapter 7 Administrative Procedures
© 2017 Harmonic Inc. All rights reserved. 214 Harmonic MediaGrid Release 4.1
Powering Down a Harmonic MediaGrid System
Figure 7–3: Shut down all ContentDirectors in a cluster
4. A confirmation message appears. Click
OK.
5. Scroll down to the
ContentDirectors section of the page. Make sure the Network Status of the
ContentDirectors indicates
Not Responding. Note that it may take a few minutes for the status
to change, depending on the length of the discovery cycle and the status of other devices in
your network.
6. Disconnect the power cords from the ContentDirectors.
Once the ContentDirectors are shut down, the
Shutdown all ContentBridges in a Cluster button
will be activated.
7. Click
Shutdown all ContentBridges in a Cluster. When the confirmation message appears,
click
OK.
8. Scroll down to the
ContentBridges section of the page. Make sure the Network Status of the
ContentBridges indicates
Not Responding. Note that it may take a few minutes for the status
to change, depending on the length of the discovery cycle and the status of other devices in
your network.
9. Disconnect the power cords from the ContentBridges.
Once the ContentBridges are shut down, the
Shutdown all ContentServers in a Cluster button
will be activated.
10. Click
Shutdown all ContentServers in a Cluster. When the confirmation message appears,
click
OK.
11. Scroll down to the
ContentServers/ContentStores section of the page. Make sure the
Network Status of the ContentServers and ContentStores indicates Not Responding. Note
that it may take a few minutes for the status to change, depending on the length of the
discovery cycle and the status of other devices in your network.
12. Power down the ContentServers and ContentStores as follows:
 ContentServer 3000 (3U): Press the red power button on the control panel on the front of the
server and hold for five seconds. Once the disk drive LEDs are off, disconnect the two power
cords from the back of the server.
 ContentStore 3160 (3U): Press the red power button on the control panel on the front of the
device and hold for five seconds. Once the disk drive LEDs are off, disconnect the two power
cords from the back of the device.
 ContentServer 4000 (4U): Press the power button on the control panel and hold for four
seconds. Once the disk drive LEDs are off, disconnect the two power cords from the back of
the server.
 ContentStore 4240 (4U): Press the power button on the control panel and hold for four
seconds. Once the disk drive LEDs are off, disconnect the two power cords from the back of
the server.
 ContentStore 5840 (5U): Move all power supply switches to the “off” position. Once the front
panel LEDs are off, disconnect the power cables from the power supplies.