Harmonic MediaGrid - Page 67

Chapter 2 System Installation with the Content-
Server 4000 Series
© 2017 Harmonic Inc. All rights reserved. 67 Harmonic MediaGrid Release 4.1
Expanding a Harmonic MediaGrid 4000 Series System
7. On the ContentServer Properties page in SystemManager, verify that the Status field for
Controller 0 changes to
Connected.
8. Power down the bottom controller by clicking the
Shutdown button for Controller 1, and then
click
OK to confirm.
9. Connect one end of the SAS cable to an open SAS port on the bottom controller, and then
connect the other end of the cable to SAS-1 on the bottom expander module on the
ContentStore.
10. Power on Controller 1 by pressing the power button on the front panel of the ContentServer.
11 . O n t h e
ContentServer Properties page in SystemManager, verify that the Status field for
Controller 1 changes to
Connected.
12. Add the new ContentStore to the associated group as follows:
a. From the
Cluster Properties page, click the associated Group ID.
b. From the
Group Properties page, select the device you wish to add to the group, and then
click
Add Server(s) to this Group.
c. Click
OK to confirm, and then click Done.
13. Navigate to the
ContentServer Properties page and click the Failback button to balance the
ContentServer controllers.