User Manual
Operation and Management
Page 4-46 (Rev. 4.1/ SW v1.60/ December 2006)
4.2.4. Filtering
Filtering is a licensing required feature that allow the user to define a method
for PID Filtering on PVR 6000 ASI and IP output ports.
The following summarizes the Filtering procedures, using both Front Panel and
Web-Based Management interfaces:
FILTERING THROUGH THE FRONT PANEL
In order to use filtering mode thru the front panel perform the following steps:
• Configure ASI or/and IP outputs to filtering mode (see section
4.2.3.2:
ConfigurationÎStreamÎOutputÎASI Output SourceÎAfter Filtering
ConfigurationÎStreamÎOutputÎIP Output SourceÎAfter Filtering
• Access the general screen by navigating to:
RootÆConfigurationÆStreamÆFiltering
Filtering
1-2-2-4
1 General
2 Service
3 PID
• Set the following parameters at the General sub menu: strategy, mode, Bit-
rate mode and bit-rate. (see section 4.2.4.1)
ConfigurationÎStreamÎ FilteringÎGeneral
• In case that the service filtering strategy is chosen, select the services (see
section 4.2.4.2)
ConfigurationÎStreamÎ FilteringÎService
• In case that the PID filtering strategy is chosen, select the PIDs (see section
4.2.4.3)
ConfigurationÎStreamÎ FilteringÎPID
FILTERING THROUGH THE WEB-BASED MANAGEMENT
In order to use filtering mode thru the front panel perform the following steps:
• configure ASI or/and IP outputs to filtering mode:
StreamÎGeneralÎOutputÎASI Output SourceÎAfter Filtering
StreamÎGeneralÎOutputÎIP Output SourceÎAfter Filtering
To Next Page
Loading...
