User Manual
Appendix B
IP-Front End Software Upgrade Procedure
Page B-2 (Rev. 4.1/ SW v1.60/ December 2006)
10. In the Telnet prompt window, type ‘telnet <unit IP Address> 1023’ (use the
same IP Address as in step 9).
11. Type 'exit' and then Enter.
12. Type ' burn “vxw” ' and then Enter.
13. Type ' “burn “ird” ' and then Enter.
14. Power off the PVR 6000.
15. After a few seconds, power on the PVR 6000.
16. On the PVR 6000 front panel, go to Configuration
Æ
Stream
Æ
Source and
select FRONT END (IP)
17. Verify the correct upgrading of the new SW version by going in the PVR
6000 front panel to
Status
Æ
Receiver
Æ
General and checking the SW Version
dd/mm/yy mj.mn
parameter value
NOTE
If power failure occurs during upgrade, repeat the upgrade from step 1
To Next Page
Loading...
