Contents
PHLOX II Ignition Control System
6.3.4 Terminals for shaft position pick-up sensors ......................................................... 28
6.3.5 Analogue input ....................................................................................................... 30
6.3.6 CAN-1 and CAN-2 / Modbus communication ports ............................................ 32
6.3.7 Ignition output for primary connection to ignition coils ....................................... 38
6.3.8 Requirements for installation of HV-part of ignition system PHLOX II .............. 41
7 Sensor configuration ........................................................................................................... 42
7.1 Sensor overview ............................................................................................................ 42
7.2 Configuration of sensors ................................................................................................ 42
7.3 Assigning inputs to sensors and setpoint adjusters ........................................................ 43
7.4 Measuring ranges of sensors.......................................................................................... 44
7.5 Modifying reactions to sensor errors ............................................................................. 45
8 Switching functions ............................................................................................................. 47
8.1 Complete overview of all switching functions .............................................................. 47
8.1.1 Ignition stop ........................................................................................................... 48
8.2 Assignment of digital inputs .......................................................................................... 48
8.2.1 HZM-CAN periphery module ............................................................................... 50
8.3 Assignment of communication modules ....................................................................... 51
8.4 Value of a switching function ........................................................................................ 51
9 Inputs and outputs .............................................................................................................. 53
9.1 Selectable inputs/outputs ............................................................................................... 53
9.2 Pick-up inputs ................................................................................................................ 55
9.3 Analogue input .............................................................................................................. 57
9.4 PWM inputs ................................................................................................................... 58
9.5 Digital inputs ................................................................................................................. 58
9.6 PWM outputs ................................................................................................................. 58
9.7 Digital outputs ............................................................................................................... 59
10 Configuring the control’s inputs and outputs................................................................. 60
10.1 Digital inputs ............................................................................................................... 60
10.2 Analogue inputs ........................................................................................................... 60
10.2.1 Calibration of current/voltage inputs ................................................................... 60
10.2.2 Filtering of analogue inputs ................................................................................. 61
10.2.3 Error detection in analogue inputs ....................................................................... 61
10.2.4 Overview of the parameters associated with the analogue input ......................... 63
10.3 PWM inputs ................................................................................................................. 63
10.3.1 Error detection at PWM inputs ............................................................................ 64
10.4 PWM outputs ............................................................................................................... 64
10.4.1 PWM output frequency ........................................................................................ 64
10.4.2 Assignment of output parameters to PWM outputs ............................................. 65
10.4.3 Value Range of output parameters ....................................................................... 66
To Next Page
Loading...
Need help?
General
