6 Installation
PHLOX II Ignition Control System 19
6 Installation
6.1 Mounting the control unit
Risk of deflagration or explosion of unconsummated fuel gas!
Before running engine ensure the fuel system is leak proof.
Bleeder valves are compulsory on intake side and exhaust side.
Intake and exhaust side have to be realized in adequate dimen-
sion.
Risk of injury by falling or sharp-edged devices!
During installation lose device or tools might fall down. Electric
connectors and plugs might be sharp-edged.
Use some personal protective equipment.
Risk of injury by rotating parts!
The triggre disk be prevented from touch by an adequate cover
when engine is running.
To ensure protection against accidental contact with life wires
PHLOX-II always has to be installed in a switch cabinet.
To Next Page
Loading...
Need help?
General
