14 Error Handling
196 PHLOX II Ignition Control System
14.4 Error parameter list
The error parameter list of the main program listed below contains descriptions of the
causes of each single error and of the control unit's response. Furthermore, it lists the ap-
propriate actions to be taken to eliminate the error in question.
Errors are grouped in ascending order with the numbers 3001 ... 3099, 13000 ... 13099,
23000 ... 23099 Each number corresponds to a group of errors of up to 14 single error
states and two additional pieces of information. Error states are structured in bits. If several
errors belonging to the same group are set at the same time, the relevant combination of er-
ror bits is shown in hexadecimal format. In DcDesk 2000 there is a special window indicat-
ing the current errors, in which each individual error status and a short description are dis-
played.
At least one of the errors from 0 to 13 (0x0001 ... 0x2000) of each error group has a mean-
ing, which is described in the following section.
Error 14 is set (0x4000) when all other active errors of this error group are warnings only.
Error 15 means that at least one of the errors 0…13 of this error group has led to an emer-
gency shutdown (0x8000).
Errors which have not been used are not described.
The following table shows an overview of the individual errors of an error group, together
with the respective code and a description of the errors 14 and 15, which are present in in
each error group. The errors 14 and 15 are not included in the following description of the
individual error groups.
To Next Page
Loading...
Need help?
General
