To ensure protection against accidental contact with life wires
PHLOX II always has to be installed in a switch cabinet.
All wiring must be carried out exclusively by trained personnel and
conform with current standards and regulations.
The electrics must be connected in accordance with the wiring dia-
grams provided by HEINZMANN and by the plant builder. Only
specified cable types may be used for wiring. All indicated cable
cross sections allways must be adhered.
Always switch off power before carrying out maintenance work or
demounting components of the system!
PHLOX II housing must be connected to PE (protective earth) at its
specific and indicated terminal!
Keep away from high voltage device (output-connector, ignition-
coils, high voltage wires, spark plug connectors etc.) and never
touch it while system is switched on.
High voltage devices have to be isolated adequately.
Protection against accidental contact has to be established by user.
The equipment does not have some insulation between high-voltage
circuits and SELV circuits (safety extra low voltage)!
Any measuring instruments for diagnosis of high voltage have to be
isolated adequately.
To Next Page
Loading...
Need help?
General
