Heinzmann PHLOX II IC-08 User Manual

6 Installation
PHLOX II Ignition Control System 27
6.3.3 Digital inputs and outputs
Category
S3++ – signal terminal
Designation
Wires for 2× independent digital indut/outputs:
Terminal 16 (DIO1 - digital In/Out No. 1),
terminal 3 (DIO2 - digital In/Out No. 2)
Function of terminals
2 universal terminals for discrete signals, configurable for operating elements such
as switches, actuators, relays, lamps etc.
Each DIOx is configurable as:
- low-side DI,
- high-side DI,
- low-side DO,
- low-side PWM-In,
- low-side PWM-Out
Range
0 V ... +Bat. - Potential
Connected to
PHLOX wire-terminals in control cabinet and relays, lamps or other ECU.
Type of cord used
Wire 1.5 ... 2.5 mm
2
, unshilded
Max. length
< 30 m
Note
Cable to the control cabinet is part of PHLOX II input cable harness
Recommendation for test
DIO1-terminal in PWM-output mode is translating PWM=50%;
DIO2-terminal in PWM-input mode is reciving them.
See test arrangement.
Example of a DIO
Low-side
out
- Bat.
T. 1
T. X
Standard actuators and sensors
Power
supply
+24 V DC
0V
Other ECU:
digital- or
PWM-input
State-
supervision
+12V
Pull-down
/pull-up
DIOx.
PHLOX II

Heinzmann PHLOX II IC-08 Specifications

General

Brand	Heinzmann
Model	PHLOX II IC-08
Category	Control Systems
Language	English