HeMaTech 3925-0050 - Page 59

Command reference Menu 3. SETUP
EN 3925-0060 V207-00 MANUAL R03.doc
HeMaTech Prüftechnik
59
Error number:
The two-digit numerical value specifies the type of the error of the executed test pro-
gram that has occurred:
00
No Error
01
No operating pressure
02
Memory card missing
03
Program missing
04
Transmitter defective
05
Pressure switch S2 defective
06
Pressure switch S3 defective
07
Pressure not adjustable
08
No pressure in test system
09
No pressure in specimen
10
Coarse leak in reference volume
11
Pressure after filling valve
12
Shut-off valve open
13
Leak in reference volume
14
Series fault
15
Temperature value too low
16
not available
17
Overflow absolute pressure
transducer
18
Limit contact
"Leak" cannot be reached
19
Pressure increases after shutting
off
20
Apex not reached
21
Differential pressure switch not off
22
Differential pressure switch not on
23
Filling pressure too low
24
Filling pressure to high
25
Test pressure too low
26
Test pressure to high
27
Pressure system not adjustable
28
Rated pressure out of range
29
Incorrect pre-selection
30
Hook 1 missing (optional)
31
Hook 2 missing (optional)
32
Hooks 1 +2 missing (optional)
33
Pressure switch S4 defective
34
Pressure correction value too high
35
Pressure in reference volume to
low or flow-in time too short
36
Pressure in reference volume too
high
37
Test pressure in sequence too low
38
Test pressure in sequence too
high
The output of some of the error numbers depends on device type or options. If the
number of the error is <> 0, minus symbols will be displayed for measuring value and
measuring result.
If a numerical value cannot be displayed in the defined output format, the field will be
output with "" (Code 18H) when exceeded, or with "" (Code 19H)
when fallen short of. The individual positions are separated by semicolon. The data set
is closed with a carriage return and a line feed (CR+LF).
Examples:
No Leak 00000001;01;01022000;152621;000000;01;01;00
Gross leak 00000002;01;01022000;152637;------;01;04;00
Fault 00000003;01;01022000;152718;------;01; --;25