Hi-Target HTS-420R - Deleting Fix Points

Total Station Manual
- 149 -
○
3 Press [F4] (OK) to save the
edited data after finishing
inputing. Program gives a
prompt wheter to overwrite or
not and press [F4] (OK) to
overright and save.
[Edit FixPoint]
Job : JOB1
Pt. :
N : 12.000 m
E : 13.000 m
Z :
Back
OK
P7
5.000 m
2.4 Delete Fix Pt.
Delete the selected fixpoint from the job.
Steps
Key
Display
○
1 In the interface of View
FixPoint, you can find the data
of need to be deleted by
pressing the direction key of
left or right or in the function
of finding, then press [F4] to
switch to the second page of
soft key.
If you want to change the job
which the point needs to be
deleted, you can press [Job] to
select the target job.
[F4]
Delete
Job
[View FixPoint] 7/22
Job : JOB1
Pt. :
N : 2.000 m
E : 3.000 m
Z : 1.000 m
Find New Edit
P7
○
2 Press [F1] (Delete) to start
the function of deleting data,
the interface as shown the
dialog on the right.Press [F4]
(OK) to delete data and press
[F1] (No) to cancle the
operation.
[F2]
If delete data?
Data cannot recover!
No Yes