Hi-Target HTS-420R - Firmware Upgrade Process; PIN Entry and Initial Steps

Total Station Manual
- 173 -
Back
[Time Setting]
OK
Time(24h)：
偏置模式 :
13:58:30
Input as‘hhmmss'
Time Setting
2.4 Firmware Upgrade
This function is prepared for the users to upgrade theinstrument software.
1. Input PIN code (82543), and then press key ENT, the instrument will be turned
off.
Back
[FW. Upgrade]
OK
PIN ：
偏置模式 :
2. Connected to the computer through a serial cable, after installing the correct
driver premise, open a HyperTerminal software, configure the correct serial port,
it will "bits / sec" is set to 115200, "Data Flow Control" is set to "None" and press
OK.