Hi-Target HTS-420R - Target Point Input for Area

Total Station Manual
- 97 -
9. Area
Area is an application used to calculate the polygon areas to a maximum of 20
points which connected by straights. The target points coordinate can be measured,
selected from memory or entered via keypad in same direction. And the following
three methods can be alternately performed. The calculate area is projected onto the
horizontal plane (2D).
S
P0
P1
P2
P3
P4
P5
a
Figure 9.1 Area Diagram
P0 Instrument Point
P1 Start Target Point
P1~P5 Target Point
a Perimeter, polygonal length from start point to the current measure
point.
S Calculated area always closed to the start point P1, projected onto
the horizontal plane.
Steps
Key
Display
○
1 Select “Program”
from the [Main
Menu] window, then
press [PAGE] switch
to second program
list and press [F1] or
number key [5] to
enter the Area
application.
[PAGE]
+
[F1]
or
[5]
F1
[Program]
F2 F3 F4
F1 Area
F3 COGO
F4 Road
F2 Remote Height
(5)
(6)
(8)
(7)
2/2