Hi-Target HTS-420R - Page 162

Total Station Manual
- 161 -
○
2 In “Export Data”
menu, press [F1] or
[1] entering “Export
job data” function.
[F1]
or
[1]
Job
[Job Data]
Export
Data Type：
Meas. PT
Job ； DEFAULT
Mode ：
RS232C
○
3 Press [F1] to select
job that you need to
export, then press [F4].
[F1]
[F4]
[Select Job]
JOB1 *
JOB2
JOB3
JOB4 [SD]
View New OK
○
4 Press [◄], [►] key
to select data type that
you want to export.
[◄]
[►]
Job
[Job Data]
Export
Job ： DEFAULT
Data Type：
Format ； Meas Fmt(*.htf)
Meas. PT
Mode ：
UDisk
○
5 Two methods to
use: RS232C, UDisk.
Press [◄], [►] key to
select transfer method
(mode).
If choosing RS232C,
software on the
computer should be
ready, and then press
[F4] to start export.
If choosing UDisk, the
UDisk should have
been plugged in, then
press [F4] to start
[◄]
[►]
[F4]
Job
[Job Data]
Export
Data Type：
Meas. PT
Job ； DEFAULT
Mode ：
RS232C
Job
[Job Data]
Export
Job ： DEFAULT
Data Type：
Format ； Meas Fmt(*.htf)
Meas. PT
Mode ：
UDisk