Hi-Target HTS-420R - Page 22

Total Station Manual
- 21 -
○
4 Input point number and N,
E, Z values, by pressing ENT to
move cursor to next input
box.
[ENT]
[Input Coord.]
Job : DEFAULT
Pt. :
N :
E : 15.012 m
Z : 4.215|
B.S. Clear Alpha
1
3.012 m
○
5 After all values finishing
input, pressing key F4 to save
the point to the job.
[F4]
[Job]Choose another job’s points.
○
3 If required point not exists
in the job, user can choose
another job’s points.
[F3]
1
Job Zero Find
[Find Pt.]
Job :
Pt. :
JOB1
Select job or input coord.!
Coord.
○
4 Entering job list by
pressing key F1, choose the
particular job and press ENT
or F4 to commitchoosing.
[F1]
[F4]
[ENT]
View New OK
[Select Job]
JOB1
JOB2
JOB3
JOB4
○
5 Entering searching point
number. If using input point,
press key F2 (Zero) or F3
(Coord.)※
1
[ENT]
*
Job Zero Find
[Find Pt.]
Job :
Pt. :
JOB1
Select job or input coord.!
Coord.