Hi-Target HTS-420R - Creating a New Job

Total Station Manual
- 56 -
○
2 Press [F2](New) and then
enter the Create a New Job
screen.
Press [F4](OK), the displayed
job will be set as current job
and then back to Pre-Settings
screen.
[F1]
[Set Job]
Job : DEFAULT
Operator:
Date : 20150515
Time : 14:10:20
List New OK
○
3 If the instrument is fitted
with SDCard, there willfirstly
showthe diskselection screen.
In this screen, user can select
the disk through Up or Down
key. Then press [F4](OK) to
confirm.
A: Local Disk
B: SD Card
[Select Disk]
B:SD Card
Prop. OK
A:Local Disk
○
4 Continue to show New Job
screen. Input the new job’s
name, operator, etc. Press
[ENT] to finish one input item
and thecursor moves to the
next input
itemautomaticallyat the same
time. ※
1
Input
job’s
data
+
[ENT]
[New Job]
Job :
Operator:
Note1 :
Note2 :
date : 20150515
Time : 14:10:20
Back OK
JOB1
○
5 Press [F4](OK) to complete
setting a new job after
finishing all the inputs. This
job will be set as the current
job. Then back to the
Pre-Settings screen.The
completed setting item is
marked with [*].
[F4]
Job Setted！