Hi-Target HTS-420R - Page 61

Total Station Manual
- 60 -
name and press [F4](Find). If
the point is found, press [OK] in
the [Find Pt.] list screen to set it
as station. Program enter input
instrument height screen. If the
point doesn’t exist, press
[F3](Coord.) to input the
coordinates of N, E and Z. Set
this point as station.
[Zero]: Set this point’s all
coordinates as 0 and set the
point as station.
[Coord.]: Enter [Input Coord.]
screen. Input the coordinates
and save them to the current
job.
[Input Coord.]
Job : DEFAULT
Pt. :
N :
E : 0.000 m
Z : 0.000 m
Back OK
121
0.000 m
○
4 Enter input instrument
height screen. Input the
instrument height and press
[ENT] to confirm. Then press
[F4](OK) to save and set the
station informations.
Press [ESC] then back to
previous screen. Continue to set
the coordinates of station.
Input
instru
ment
height
+
[ENT]
+
[F4]
[Set STA]
Input I.H!
IH. :
1.400 m
Back OK
○
5 Back to Pre-Settings screen.
The setting items that have
been made are marked with *.
[Surveying]
[*] F1 Set Job (1)
[*] F2 Set STA (2)
[ ] F3 Set B.S. (3)
F4 Start (4)
F1 F2 F3 F4
※
1
: The details of [Find Pt.] can be found in the chapter “Find Point”. You can also
input the wildcard "*" to search all the points.