Hi-Target HTS-420R - Page 69

Total Station Manual
- 68 -
○
2 Input the point name, and
then press [ENT] to move to
next input item to input prism
height.
Input
point
name
+
[ENT]
1
ALL DIST REC
[Surveying] 1/3
Pt. :
T.H. :
Code :
HA :
VA :
:
1.500 m
13°29′59″
90°59′23″
○
3 Input the prism height and
then press [ENT] to move the
cursor to next input item. If
needed, input the code.
Input
prism
height
+
[ENT]
1
ALL DIST REC
[Surveying] 1/3
Pt. :
T.H. :
Code :
HA :
VA :
:
1.500 m
13°29′59″
90°59′23″
○
4 Press [F1](ALL) or press
[F2](DIST) and [F3](REC) to
start measuring and record
the measured data. This data
contains angle, distance and
coordinates. Press [PAGE] to
switch the display mode of
the data.
[F1]
or
[F2]+[F3]
1
ALL DIST REC
[Surveying] 1/3
Pt. :
T.H. :
Code :
HA :
VA :
:
1.500 m
13°29′59″
90°59′23″
<<<<<<
○
5 After finishing measuring
one point, the point name
automatic plus one. Press
[F1](ALL) or press [F2](DIST)
and [F3](REC) to continue
measuring next point. At this
time, the screen remains the
last measured data which can
be looked over by pressing
[PAGE].
2
ALL DIST REC
[Surveying] 1/3
Pt. :
T.H. :
Code :
HA :
VA :
:
1.500 m
13°29′59″
90°59′23″
10.044 m