○
3
A：
The program searchs the
point name in the job and
show the result dialog.
The match points will be
listed, press [F4](OK) to
identify selected point
and back to Stakeout
screen. (If the input is
wildcard "*", the program
will show all the points of
the current job.)※
2
B：
If there is no match point
in the job, the program
prompts“Pt. not
found!”.And then go in
Find Point In Job screen.
User can input a point or
select a point from
another job and then
back to Stakeout screen.
※
1
：The settings of job, station and orientation have been elaborated in detailIn the
previous chapters, here is no longer repeat. Refer tochapters“Setting The Job、
Setting The Station、Setting The Orientation”.
※
2
：Unlike the other place's points list, the stakeout points are ordered by time.In
the stakeout points list, the newest point is at the back and the fix point is in the
front ofmeasured point. But in the other points list, the newest point is at the
back and the measured point is in the front offix point.
To Next Page
Loading...
