ENGINE (J05E)/TROUBLESHOOTING 2–69
1. Set the starter key to the "LOCK" position.
2. Connect the connector of the engine ECU.
3. Connect the vehicle to HINO DX Ⅱ .
4. Set the starter key to the "ON" position.
5. Erase the malfunction history and set the starter key to the
"LOCK" position.
6. Connect the EGR controller connector.
7. Set the starter key to the "ON" position.
8. Check that the EGR controller communication failure (U010A) is
not detected.
8
Inspect the EGR controller [HINO DX Ⅱ ]
Did the EGR controller communication failure (U010A) disappear?
Go to step 9. Replace the EGR controller.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
To Next Page
Loading...
Need help?
General
